Make a 3V Power TapeBlock

To make a Power TapeBlock that can be connected to other TapeBlocks to make them work.

VIDEO3VPowerTapeBlock

Decorative: LEDs laid out in the shape of an M

Material

  • 3V CR2032 Battery
  • Battery holder
  • Conductive Tape
  • Foam Block

Decorative: LEDs laid out in the shape of a long I

Instruction

  • Wrap two parallel rows of conductive tape all the way around the short side of a foam block.
  • Make sure that the two rows of tape are about 1cm apart and do not touch each other.
  • Position the battery carrier over the two pieces of conductive tape so that one pin is over each piece of tape.
  • Push both of the pins into the conductive tape
Decorative: LEDs laid out in the shape of a P

Problem Solving

  • If the Power TapeBlock is not working check that the pins in the Battery holder are touching both pieces of conductive tape