Make a 3V Power TapeBlock with wire connections

To make a Power TapeBlock that can be connected to other TapeBlocks to make them work by using tape and wire rather than alligator clips.

VIDEOWirePower

Decorative: LEDs laid out in the shape of an M

Material

  • Foam block
  • Conductive tape
  • USB Buck converter cable
  • Light TapeBlock
  • Power bank or USB A Plug
  • Scissors
  • Wire Stripper

Decorative: LEDs laid out in the shape of a long I

Instruction

  • Take a foam block and ensure it is clean and dry
  • Cut the alligator clips off the buck converter cable, separate the wires and strip about 1cm off the end of the wire with wire stippers
  • Wrap conductive tape around the foam block, leaving a longer end not stuck to the block
  • Place each of the wires under the conductive tape on the block and push the tape down firmly
  • Attach a Buck converter USB cable to the power bank.
  • Place a Light TapeBlock next to the power cable block, ensuring it connects to the circuit.
  • The light bulb should light up, demonstrating the functionality of the powered tape block.
  • The block can be reused for multiple projects.
Decorative: LEDs laid out in the shape of a P

Problem Solving

  • Ensure that the conductive tapes are not touching each other
  • Check that the exposed end of the wires are not touching each other
  • Check that there is enough of the end of the wire stripped to make a good connection
  • Check the direction of the Light block